What do our operators need to pay attention to when operating automatic assembly equipment? Many new colleagues are not very clear, so please see the use of automatic assembly equipment we have below. Automatic assembly equipment

First, when the automatic assembly equipment is being cleaned up, the operator should always observe the ammeters of the six shot blasters. If it is higher than 25, the sand amount should be adjusted. It is best to control it below 22. If the inverter is stopped during the work Next, refer to the fault description reference processing according to the number of explanations.

Second, the maximum frequency of the mechanical equipment is set. This frequency corresponds to the rated speed of the automatic assembly equipment which can reach about 3000 rpm. If you want to change the speed, you can turn the knob on the inverter. The frequency value displayed above is decreasing. It is not that the speed is decreasing.

Third, when operating the left and right rollers of the automatic assembly equipment, the knob should be at the lowest speed, and the switch should be in the power off state, then press the start button on the operation platform, and then turn on the switch on the controller. At this time, turning the knob to adjust the speed can turn the knob to the lowest position when the power is off, then turn off the switch on the controller, and then press the stop button on the console.

Fourth, the automatic assembly equipment is provided with any of the emergency stop button and the key switch to turn off either, then the entire line will stop.

Fifth, when the automatic assembly equipment is in production, it needs to be started in order, otherwise it will not run.

Sixth, if there is a failure in one of the parts during operation, the latter will also stop. Non-standard automation equipment